hobbylock 797
stich length wheel |
|
Sallyg47
Member since 11/4/09
Posts: 5 |
Login to reply to this post
Date: 11/5/09 4:37 PM I bought a 797 on ebay and it looks clean and well maintained but then this is my first serger! My question is the manual says to set the stich length hold down the feed dog stop and turn the wheel. The problem is the wheel won't turm am I doing something wrong? |
Betakin
Advanced
AZ USA
Member since 4/22/04
Posts: 7142 |
Login to reply to this post
Reply to Sallyg47
Date: 11/5/09 6:41 PM Do you have to "push in" the little wheel first..then turn? I had to do this with my very old Babylock but I didn't have to (hold the feed??). I have never used this Hobbylock model my Pfaff serger was very different.
-- Edited on 11/5/09 6:45 PM -- |
Sallyg47
Member since 11/4/09
Posts: 5 |
Login to reply to this post
Date: 11/6/09 12:56 PM unfortunatly it doesn't push in but if you take the screw out you can move it but then it doesn't push in again to set it. I checked the belt and it looks good so I am at a loss. Supposedly when I bought it, it was in excellent condition (of course!) Any one have one of these machines? |
Sallyg47
Member since 11/4/09
Posts: 5 |
Login to reply to this post
Date: 11/9/09 2:19 PM ok so the balance wheel is also the stitch length wheel, it won't move and when I press the foot pedal nothing moves just buzzes is it possible the motor isn't any good? |
|Login|Help]
Printable Version
